You were doing something important when the electricity blackout happened. Luckily, you have your generator ready in the garage because you know something like this could happen.
But when you try starting the engine, it won’t budge.
Now that is frustrating. It’s never easy dealing with a generator that refuses to start, especially when you are in a hurry.
Unfortunately, this is a common DuroMax problem that you can’t ignore. It happens all the time to many people.
And that is why you need to understand everything about it and how to get around the issue.
You need to understand the reasons your generator is not starting. And we have listed a few of them here.
A Faulty Plug
It is another common problem DuroMax Generators face. If your generator is not starting, it could be that the spark plug is not working properly.
Perhaps it’s burnt and cannot produce the spark needed to begin heating the fuel. Also, check if any wires are not connected well.
Checking the plug is relatively easy. It should take a few minutes to pull it out and observe with your eyes.
Here are some ideas:
Covered in thick oily liquid. It means the spark is getting very little oil and too much gasoline.
Tan or white. The fuel is good, but there is not enough oxygen to spark it.
Replacing the plug should be the best solution for this issue. However, be sure to replace it with a new one.
A used one will give you the same problems or even worse.
Note:
The electrical current generated by a spark plug can be fatal. Therefore, please do not attempt to handle it with your bare hands.
Ensure the plug is well connected in place and secure before you try starting the generator again.
Check The Main Control Switch
The generator comes with a central control switch that must be at the “off/reset” position for the generator to start.
Someone might have pressed the emergency stop or initiated the alarms on this switch, turning off the automatic settings of your machine.
Check to ensure it’s in the proper position.
No Or Low Fuel
Your generator will not start if there is no fuel. You must ensure it has proper fuel levels before using it.
It is one of the DuroMax Problems most people miss.
One indication of low fuel is when the generator starts and stops suddenly. Or it will refuse to create all the same.
Perhaps you filled the tank and are sure the fuel is no problem; what else could be the issue? Check if the fuel inlet is open.
A valve shuts the fuel flow when the generator is not in use. It could be that you forgot to open it, and now there is no fuel flow to the carburetor.
But what if you have fuel, it’s the inlet open, yet it still won’t work? Another explanation could be you are using bad fuel.
Contaminated fuel will not only cause starting problems but can also affect your engine in more severe ways.
Also, ensure the fuel filter is not junked. It could cause a lack of proper flow in the fuel lines, blocking the engine from starting.
Cold Engine
If your DuroMax Generator has been sitting without use for a long time, it might have become too cold to start.
It happens a lot, especially in colder regions, and requires one to understand why their generators may be affected.
If that is the case, continue trying until the engine is ready to start.
Pulling the starter over and over might seem hard, but that could be the only solution where all the other factors mentioned above are green.
Common Problem #2: The Generator Stalls During Operation
Your generator might start working correctly. But then, it starts to falter.
For instance, the engine seems to increase and reduce its vibrations automatically.
It is another common problem with Duromax generators you should be aware of. It’s not only for this brand but many other generators.
A few things could be causing this:
A Faulty Spark Plug
It could prevent the production of enough power to keep the engine running. Try changing the plug and get a new one that has more energy.
Dirt
Dirty air and oil filters will also make your generator operate inefficiently. These filters remove contaminants that might build up over time, wearing down the engine.
You can clean or replace them to get better performance.
Unclean Carburetor
If your DuraMax generator suddenly stops working, you must check the carburetor. It is among the most sensitive parts of your engine that must be kept clean.
The simplest method to resolve this is by cleaning the carburetor. You might need to remove the component safely and clean it without affecting its operation.
If you are not sure, let an expert help you.
Your generator should run efficiently at all times. Once you turn it on, it should give you all the power to run your appliance.
But when it begins to stall, you should know there is an issue and check the parts mentioned above.
Common Problem #3: Overheating
Another common problem with DuraMax generators is overheating. Although not many people have faced this, it’s something that could happen at any time.
Two common issues may cause this:
Low Coolant
Coolant is an important aspect of any engine. It’s a fluid that keeps your generator at the right temperatures.
You need to ensure the coolant is at the right levels.
Leakages
Another common problem with generators is oil, fuel, and coolant leakages. You can notice this through an increased refilling of these fluids.
It will help a lot to check and seal any leakages.
Overheating can be very dangerous for you and your generator. Therefore, you must fix it as soon as possible.
If the issue is extremely serious, avoid using the machine until it is fixed.
Also, consider using the generators in a well-ventilated room. The heat produced by the engine could fill out a small, poorly ventilated room, leading to bigger problems.
Conclusion
It is paramount to understand your DuroMax generator and the common problems that come with it. This knowledge will help you prevent more serious issues.
We have summarized most issues in the three points above, hoping it helps you in troubleshooting.
Regular inspection and routine maintenance is one way of ensuring you get the best from your machine.
The generator will function properly for a long time when you have time to check it. Even when you don’t need it too often, keep it in check for rainy days.
Luckily, troubleshooting it is not as hard as it sounds. All you need is to remember these common generator problems and refer to them whenever you feel something is wrong.
