Table of Contents
When reading reviews before buying shotguns, you almost do not see the harmful aspects of the product.
The goal is to sell the product, making it look flawless. But we all know there is nothing perfect out there.
Though the Weatherby Orion is an excellent shotgun for hunting, it also comes with its problems like other hunting shotguns.
And this article has compiled some of the common problems you might likely face when using your Weatherby Orion for hunting.
Read on!
Common Problems With The Weatherby Orion Shotguns
When it comes to problems that affect firearms, there seems to be a mixed reaction depending on individual gun use experience.
Sometimes, the gun owner plays a significant role in some of the problems, but other times they are purely manufacturer errors.
Below are some of the compiled problems that affect the Weatherby Orion firearm.
Bore Obstructions
Bore obstruction is not a problem peculiar to the Weatherby Orion shotgun, as it also affects any other gun because it is caused by dirt.
When you continue to use your gun, the shells leave some debris behind that can impact the trajectory of your subsequent shots.
And as time goes on, this debris or dirt accumulates to cause problems further down the line. So, it would be best if you dealt with it immediately.
Solutions
The best way to deal with bore obstructions is to continually clean your gun after usage to ensure that every debris is off.
And ensure that regular maintenance is being carried out from time to time.
How To Check For Obstructions
Before you start the process, ensure that the gun’s muzzle is pointed in a safe direction and remove your fingers from the trigger.
- Put the manual safety slide in the safe position.
- Open the breech of the firearm.
- Inspect each bore for obstructions from the breech end to the muzzle.
How To Clear Obstructions
- While the breech is open, slide the shotgun bore cleaning tool into the bore entering through the breech end and exiting from the muzzle.
- If this fails to clear the bore, contact Weatherby or visit your local gunsmith.
How To Close The Breech
- Put the manual safety slide in the safe position.
- Use one hand to hold the buttstock behind the receiver tang of the shotgun and your other hand on the forend.
- Apply pressure upward with the hand holding the forend and raise the muzzle until the barrels stop with the breech closed.
- The top lever will snap from the left to the center position that aligns with the safety slide and muzzle when the breech is closed correctly.
Cracked Parts
The problem of cracked parts is synonymous with guns that are not built with steel.
The reason is that steel guns are built to withstand the force produced by your guns when shots are fired.
So, a gun made out of wood will surely get cracked faster than that steel. It often starts as a mark that will eventually crack open.
You should make an early move to fix it because it is also a sign that your gun is old and needs to be changed.
If left unfixed, it can impact other areas leading to a more significant malfunction.
Solution
Send the gun to a professional gun repairer to get it fixed.
But, if you have warranty coverage, you can send it to the manufacturers as it might be a production problem and not due to aging.
Misfiring And Timing Issues
Almost all guns can misfire, so this is not peculiar to the Weatherby Orion gun.
A misfire is the failure to initiate the priming mixture after the firing pin has appropriately struck the primer or the rim of a rimfire case.
Also, a misfire occurs when the powder falls to ignite by the primer, and some often refer to it as failure to fire.
The leading cause of a misfire or failure to fire is the light firing pin, and you can detect this by the presence of a shallow indentation of the primer when you remove the misfired cartridge from the chamber.
Sometimes, misfiring problems are confused for hangfire; though similar, they have their differences. The hangfire is more of a delay in a shot that will be fired.
It is hazardous to assume a misfire when it is a hangfire, so always assume a hangfire when the gun fails to fire immediately.
Solution
- You can service the firearm by dismantling it and applying oil to its part.
- You can send it to the manufacturers to get it fixed or visit your local gunsmith.
Tips
When your gun fails to fire, ensure you point it in a safe direction and wait for some minutes before unloading the firearm.
If you fail to adhere, it could lead to severe damage to you and your firearm.
Slamfire
The slamfire problem is sometimes referred to as a runaway gun, and it is an unintended, premature discharge of a firearm when reloading it.
And this occurs when the bolt slams forward and the firing pin ignites the primer.
Though this problem is minimized in modern guns, it is still possible, so watch out for it.
Solution
- When you notice a slamfire, remove the magazine immediately.
- Take the gun to a professional for proper inspection and fix it.
Failure To Feed
This problem occurs when the next cartridge fails to feed into the firearm chamber, which can be caused in several ways.
The causes of failure to feed are a dirty feed ramp, damaged magazine and cartridge, and incorrect gas setting.
Solution
- You can employ the tap, rack, and bang drill to solve this problem.
- You can dismember the gun to ensure that everything is in order.
- You can send it to a professional for it to be fixed and adequately examined.
How To Dismember The Weatherby Orion
Before you start the process, ensure that the gun’s muzzle is pointed in a safe direction and remove your fingers from the trigger.
- Put the manual safety slide in the safe position.
- Separate the forend from the barrel assembly.
- Use one hand to hold the buttstock behind the receiver tang of the shotgun and your other hand on the barrel assembly ahead of the forend lug.
- Use the thumb of your hand holding the buttstock, push the top lever to the far right, and hold.
- Apply pressure downward with the hand holding the barrel assembly, and push the muzzle down gradually until the barrel assembly separates from the receiver and the buttstock assembly.
Conclusion
Every firearm has its strengths and weaknesses, and gun reviews only show the strength. But it is essential to have a balanced view to make the right decisions.
These highlighted problems are not always sure that they will occur. But it is better to be prepared knowing what to do when you encounter these problems.
Also, you could help those around you with some of these tips to improve their Weatherby Orion hunting experience.
